I was recently baffled to see that when I entered configuration mode within a VLAN interface on a Catalyst access layer switch that I could not set any IPv6 options! It turns out that by default, SDM prefers what it calls the “desktop default” template. This means it is optimized for IPv4 and does not include IPv6 support. Fortunately a quick but painful fix to this is to change the prefered SDM template from “desktop default” to “dual-ipv4-and-ipv6″:

Switch>enable
Switch#config t
Switch(config)#sdm prefer dual-ipv4-and-ipv6
Switch(config)#end
Switch#reload

Unfortunately, you will need to reload (reboot) the device in order for the changes to take place, which will obviously incur annoying downtime for your users. Once the device has reloaded you can verify by issuing a show sdm prefer command which should look something like this:

Switch#show sdm  prefer
 The current template is "desktop IPv4 and IPv6 default" template.
 The selected template optimizes the resources in
 the switch to support this level of features for
 8 routed interfaces and 1024 VLANs.

  number of unicast mac addresses:                  2K
  number of IPv4 IGMP groups + multicast routes:    1K
  number of IPv4 unicast routes:                    3K
    number of directly-connected IPv4 hosts:        2K
    number of indirect IPv4 routes:                 1K
  number of IPv6 multicast groups:                  1.125k
  number of directly-connected IPv6 addresses:      2K
  number of indirect IPv6 unicast routes:           1K
  number of IPv4 policy based routing aces:         0
  number of IPv4/MAC qos aces:                      0.5K
  number of IPv4/MAC security aces:                 1K
  number of IPv6 policy based routing aces:         0
  number of IPv6 qos aces:                          0.5K
  number of IPv6 security aces:                     0.5K

Now you should be able to configure IPv6 interfaces and ACLs.

Cisco, IPv6, Networking 3750, Catalyst, Cisco, IOS, IPv6, Networking